1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the intake actuator connector.
|
3. |
Verify that the intake actuator operates to the fresh position
when connecting 12V to terminal 4 and grounding terminal 3.
Verify that the intake actuator operates to the recirculation
position when connecting in the reverse.
|
4. |
Connect the intake actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 6 and 5.
Specification
|
7. |
If the intake actuator is not operated well, substitute with a
known-good intake actuator and check for proper operation.
|
8. |
Replace the intake actuator if it is proved that there is a problem
with it.
|
Manual transaxle
Manual transaxle operation
The manual transaxle has 6 forward gears.
This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized
in all forward gears so shifting to ei ...
Oil Pan: Removal
1.
Remove the under covers (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
...
Trunk Lid Adjustment
1.
After loosening the trunk lid hinge (A) mounting bolt, adjust
the trunk lid by moving it up or down, or right or left.
2.
Adjust the tru ...