1. |
Inspection of parts
Each part, when removed, should be carefully on suspected for
malfunction, deformation, damage, and other problems.
|
2. |
Arrangement of parts
All disassembled parts should be carefully arranged for effective
reassembly.
Be sure to separate and correctly identify the parts to be replaced
from those that will be used again.
|
3. |
Cleaning parts for reuse
All parts to be used again should be carefully and thoroughly
cleaned by an appropriate method.
|
1. |
Oil seals
|
2. |
Gaskets
|
3. |
O-rings
|
4. |
Lock washers
|
5. |
Cotter pins (split pins)
|
6. |
Plastic nuts
Depending on their location.
|
7. |
Sealant should be applied to gaskets.
|
8. |
Oil should be applied to the moving components of parts.
|
9. |
Specified oil or grease should be applied to the prescribed locations
(oil seals, etc) before assembly.
|
Specifications
Transaxle type
M6CF1
Engine type
Gasoline 1.6 GDI
Gear ratio
1st
3.769
2nd
2.045
3rd
1.286
...
Starter: Cleaning
1.
Do not immerse parts in cleaning solvent. Immersing the yoke assembly
and/or armature will damage the insulation. Wipe these parts with a
cloth only.
...
Wheel Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...