Kia Rio: Measurement Point

Measurements should be taken at the center of the hole.

Measuring Actual Dimensions

1. These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurem ...

Checking Cables And Wires

1. Check the terminal for tightness. 2. Check terminals and wires for corrosion from battery electrolyte, etc. 3. ...

See also:

Components Location
1. PCV valve 2. Canister 3. Purge control solenoid valve (PCSV) 4. Fuel tank pressure sensor (FTPS) 5. Canister close valve (CCV) 6. Fuel level sensor (FLS) 7. ORV ...

Ignition Switch Assembly Installation
1. Install the key lock cylinder.    When assembling, the key must be insert ...

Mode Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode con ...