Kia Rio: Disassembly
Identify MLA(Mechanical lash adjuster), valves, valve springs
as they are removed so that each item can be reinstalled in its original
position.
|
1. |
Remove the mechanical lash adjusters (MLAs) (A).
When removing MLAs, mark all the MLAs for their rearrangement.
|
|
2. |
Remove the valves.
(1) |
Using the SST (09222 - 3K000, 09222 - 3K100), compress
the valve spring and remove the retainer lock.
|
(2) |
Remove the spring retainer.
|
(3) |
Remove the valve spring.
|
(5) |
Remove the valve stem seal.
|
(6) |
Using a magnetic finger, remove the spring seat.
Do not reuse the valve stem seals.
|
|
|
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...
Cylinder Head
1.
Inspect for flatness.
Using a precision straight edge and feeler gauge, measure the
surface the contacting the cylinder block and the manifolds ...
See also:
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
[CVVT System Mode]
(1) Low Speed / Low Load
(2) Part Load
(3) Low Speed / High Load
(4) High Speed / High Load
...
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS
failure.
2.
When ESC or TCS fails, only the failed system control is pr ...