Water Pump |
1. |
Drain engine coolant.
|
2. |
Loosen the alternator tension adjusting bolt (A) to loosen tension.
|
3. |
Remove the drive belt (A).
|
4. |
Remove the water pump pulley (A).
|
5. |
Remove the water pump (A).
|
6. |
To install, reverse the removal orders.
|
7. |
Fill with engine coolant.
|
8. |
Start engine and check for leaks.
|
9. |
Recheck engine coolant level.
|
1. |
Drain engine coolant.
|
2. |
Disconnect the battery negative terminal.
|
3. |
Remove the air duct and air cleaner assembly. (Refer to Engine
and transaxle assembly)
|
4. |
Disconnect the engine coolant temperature sensor connector (A).
|
5. |
Disconnect the radiator upper hose (A).
|
6. |
Disconnect the heater hoses (A).
|
7. |
Remove the water temperature control assembly (B) after disconnecting
the throttle body cooling hose (A).
|
8. |
Remove the intake manifold. (Refer to Intake and exhaust system)
|
9. |
Remove the heater pipe (A).
|
10. |
To install, reverse the removal orders.
|
Removal
•
DON’T remove the camshaft position sensor while the engine
is running or right after e ...
Back-up Lamp Switch Inspection
1.
Disconnect the back up lamp switch connector (A).
2.
Check the continuity between no. 1 and 2 terminals of backup lamp
switch. W ...
SS-A Solenoid Valve(ON/OFF) Description
SS-A solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed
at valve body.
...