Kia Rio: Water pump: Inspection
| 1. |
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
|
| 2. |
Check the bearing for damage, abnormal noise and sluggish rotation,
and replace the coolant pump assembly if necessary.
|
| 3. |
Check for coolant leakage. If coolant leaks from hole, the seal
is defective. Replace the coolant pump assembly and gasket.
|
Water pump: Removal and Installation
Water Pump
1.
Drain engine coolant.
System is under high pre ...
Water pump: Troubleshooting
Water Pump
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the bleed hole of the water pump
...
See also:
Front Fog Lamps Removal
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the fog lamp connector (A).
3.
Remove t ...
Dynamic Damper Replacement
1.
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
2.
Remove the TJ joint assembly. (Refer to DS group - “TJ joint”)
...
Front Driveshaft Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...
Copyright © www.kirmanual.com 2014-2024