1. |
Check the continuity between the terminal and the body with an
ohmmeter. If there is no continuity, replace the oil pressure switch.
|
2. |
Check the continuity between the terminal and the body when the
fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch.
|
3. |
If there is no continuity when a 49.0kpa (0.5kg/cm², 7.1psi) is
applied through the oil hole, the switch is operating properly.
Check for air leakage. If air leaks, the diaphragm is broken.
Replace it.
|
Schematic Diagram
Canister
The Canister is filled with charcoal and absorbs evaporated fuel vapor
from the fuel tank. The gathered fuel vapor in canister is drawn into the intake
manifold by the ECM/PC ...
Inspection
Clutch Pedal Inspection
1.
Measure the clutch pedal height (from the face of the pedal pad
to the floorboard) and the clutch pedal clevis pin play (measured at
the ...
Oil Pan: Installation
1.
Install the oil pan.
(1)
Using a razor blade and gasket scraper, remove all the
old packing material from the gasket surfaces.
...