1. |
Remove the engine cover.
|
2. |
Disconnect the battery negative terminal.
|
3. |
Remove the air duct and the air cleaner assembly.
(Refer to Engine and transaxle assembly)
|
4. |
Disconnect the injector extension connector (A), the VIS (Variable
intake system) connector (B) and the PCSV (Purge control solenoid valve)
connector (C).
|
5. |
Disconnect the ETC (Electronic throttle control) connector (A)
and the MAPS (Manifold absolute pressure sensor) & IATS (Intake air
temperature sensor) connector (B).
|
6. |
Disconnect the knock sensor connector (A).
|
7. |
Disconnect the PCV (Positive crankcase ventilation) hose (A) and
the PCSV (Purge control solenoid valve) hose (B).
|
8. |
Disconnect the vacuum hose (A) and the throttle body coolant hoses
(B).
|
9. |
Unfasten the filler neck assembly mounting bolts (A).
|
10. |
Remove the intake manifold (A) with the gasket (B).
|
11. |
Installation is reverse order of removal.
|
Tire Removal
1.
Remove valve core and deflate the tire.
2.
Remove the side of the tire bead area from the wheel using tire
changing machine .
...
Radiator: Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
(-) terminal (without battery sensor):
7.8 ~ 9.8N.m (0.8 ~ 1.0 ...
Rear Washer Switch Inspection
1.
With the rear wiper & washer switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace t ...