[On vehicle inspection] |
1. |
Accelerate the engine to about 3,000 rpm 3 times or more.
|
2. |
Remove the spark plug.
|
3. |
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as
below.
|
[Component Inspection] |
1. |
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug.
|
2. |
Check the electrode. Measure the insulation resistance with an
ohmmeter.
If the resistance is less than the specified value, adjust the
electrode gap.
|
3. |
Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.
|
Steering Angle Sensor (MDPS Only) Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Engine start/stop button
Illuminated Engine start/stop button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience.
The light will go off after about 30 seconds when the d ...