Kia Rio: Components
| [AMS type (OAD)] |
| 1. OAD (Overrunning Alternator Decoupler) 2. Front Bracket 3. Front Bearing 4. Stator 5. Rotor 6. Rear Bearing |
7. Rear Bracket 8. Brush Holder Assembly 9. Through Bolt 10. Rectifier Assembly 11. Rear Cover |
| [ISG/AMS type (NON-DAD)] |
| 1. Drive belt pulley 2. Front Bracket 3. Front Bearing 4. Stator 5. Rotor 6. Rear Bearing |
7. Rear Bracket 8. Brush Holder Assembly 9. Through Bolt 10. Rectifier Assembly 11. Rear Cover |
Specification
[AMS type (NON-OAD)]
Item
Specification
Rated voltage
13.5V, 90A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC ...
Circuit Diagram
...
See also:
Tightening Torques
Item
N.m
kgf.m
lb-ft
Ignition coil installation bolt
9.8 ~ 11.8
1.0 ~ 1.2
7.2 ~ 8.7
Spark plug installation
14.7 ~ ...
Removal
1.
Drain the brake fluid through the bleed plug (A).
2.
Remove the clutch release cylinder assembly (C) after removing
the tube (B) ...
Front Wiper Motor Inspection
Speed Operation Check
1.
Remove the connector (A) from the wiper motor.
1. -
2. IGN+
3. Parking
4. High
5. GND
6. Low
...
Copyright © www.kirmanual.com 2014-2024