Kia Rio: Installation
| 1. |
Install in the reverse order of removal.
|
| 2. |
Adjust the alternator belt tension after installation.
(Refer to Engine charging System - "Drive belt tension measurement
and adjustment")
|
Removal
1.
Disconnect the battery negative terminal.
2.
Disconnect the air compressor connector (A) and the alternator
connector (B), and remove th ...
Disassembly
1.
Remove the rear cover (A) after removing nuts.
2.
Remove the mounting bolts (A) and the brush holder assembly (B).
...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Check Fuses
A blade type fuse test taps provided to allow checking the fuse itself
without removing if from the fuse box. The fuse is good if the test lamp lights
up when one lead is connected to the tes ...
Driver Airbag (DAB) Module and Clock Spring Components
1. Driver Airbag (DAB)
2. Steering Wheel
3. Clock Spring
...
Copyright © www.kirmanual.com 2014-2024