Kia Rio: Adjustment
Battery Sensor Recalibration Procedure
|
If disconnecting the negative (-) battery cable from the battery during
repair work for the vehicle equipped with Alternator Managing System(AMS) function,
Battery sensor recalibration procedure should be performed after finishing
the repair work.
1. |
Turn the Iginition switch ON and OFF.
|
2. |
Park the vehicle about 4 hours under below states.
A. |
Park the vehicle about 4 hours under below states.
|
B. |
Closing the hood, trunk, and all doors.
|
|
3. |
After 4 hours later, check whether the current datas are displayed
normally or not using GDS.
A. |
Nominal capacity(AMS) = 45Ah [For Non-ISG type]
|
B. |
Nominal capacity(AMS) = 60Ah [For ISG type or Russia region]
|
C. |
State of Charge of Battery(AMS) = (0~100%)
|
D. |
State of Health of Battery(AMS) = (0~100%)
|
|
4. |
After cranking the engine 2 times or more, check "State of Function
of Battery(AMS) =(0~12V)". [For ISG system only]
|
1.
Check for DTCs.
•
If a DTC is ...
See also:
Rear Coil Spring Replacement
1.
Remove the rear wheel & tire.
(Both RH side and LH side)
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb ...
Tightening Torques
Engine Control System
Item
kgf.m
N.m
lb-ft
ECM installation bolt
1.0 ~ 1.2
9.8 ~ 11.8
7.2 ~ 8.7
ECM bracket installation ...
Filler-Neck Assembly Removal
1.
Open the fuel filler door, and then remove the filler-neck assembly
mounting screws (A).
2.
Disconnect the fuel filler hose (A) ...