Kia Rio: Starter: Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Disconnect the starter cable (B) from the B terminal on the solenoid
then disconnect the connector from the S terminal (A).
|
| 4. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
Starter: Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
See also:
TPMS Sensor Installation
Sensor Fit
•
Handle the sensor with care.
•
...
Multimedia Jack Installation
1.
Install the multimedia jack.
2.
Connect the multimedia jack connector.
...
Rear Seat Belt Replacement
Rear Seat Belt Replacement
[5 Door]
•
When installing the belt, make sure not ...
Copyright © www.kirmanual.com 2014-2024