Kia Rio: Cruise Control Switch: Inspection
Measuring Resistance
| 1. |
Disconnect the cruise control switch connector from the control
switch.
|
| 2. |
Measure resistance between terminals on the control switch when
each function switch is ON (switch is depressed).
|
|||
| 3. |
If not within specification, replace switch.
|
Measuring Voltage
| 1. |
Connect the cruise control switch connector to the control switch.
|
| 2. |
Measure voltage between terminals on the harness side connector
when each function switch is ON (switch is depressed).
|
|||
| 3. |
If not within specification, inspect the control switch resistance.
The measuring resistance value is not within specification, replace
the switch and measure the voltage again.
|
| 4. |
If resistance is OK but, measuring voltage is not within specification,
inspect the wiring harness and connectors between the switch and the
ECM.`
|
Cruise Control Switch: Installation
1.
Install in the reverse order of removal.
...
See also:
Curtain Airbag (CAB) Module Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
Fuel Pump Installation
1.
Installation is reverse of removal.
Fuel pump plate cover installation
bolt :
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb- ...
Rear-camera display
The Rear-Camera Display will activate when the back-up light is ON with the ignition
switch ON and the shift lever in the R (Reverse) position.
This system is a supplemental system that displays ...
Copyright © www.kirmanual.com 2014-2024