Kia Rio: Circuit Diagram

ECM Terminal And Input/Output signal [A/T]

ECM Terminal Function (A/T) Connector [EGGA-AG] Pin No. Description Connected to 1 Injector (Cylinder #1) [High] control output ...

Removal

   When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. ...

See also:

Input Speed Sensor Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Compressor Installation
1. Make sure of the length of compressor mounting bolts, and then tighten it with the specified tightening order. Tightening torque : ...

Photo Sensor (FATC only) Description
The photo sensor is located at the center of defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving port ...