When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
[In the case of installing used ECM]
Then the ECM key register process is completed automatically.
[In the case of installing new ECM]
Then the ECM key register process is completed automatically.
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the ECM Connector (A).
|
3. |
Remove the battery (Refer to "Charging System" in EM group).
|
4. |
Remove the mounting bolts and nut, and then remove the ECM bracket
assembly (A).
|
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description
Overdrive clutch control solenoid valve(OD/C_VFS) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the overdrive clutch.
...
Emergency starting
Connect cables in numerical order and disconnect in reverse order.
Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicl ...
Yaw-rate and G Sensor Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the front seat (LH) assembly.
(Refer to the Bo ...