Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the resonator and the air intake hose (Refer to “Intake
And Exhaust System” in EM group).
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (A).
|
| 5. |
Remove the installation bolts, and then remove the ETC module
(A) from the engine.
|
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Inspection
1.
Immerse the thermostat in water and gradually heat the water.
2.
Check the valve opening temperature.
Valv ...
Temperature Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver side shower duct (A) after loosening the screw.
...
Transaxle Control Module (TCM) Description
Transaxle Control Module (TCM) is the automatic transaxle's brain. The
module receives and processes signals from various sensors and implements a
wide range of transaxle controls to ensu ...
Copyright © www.kirmanual.com 2014-2024