Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the engine coolant temperature sensor connector (A).
|
| 3. |
Supplement the engine coolant (Refer to “Cooling System” in EM
group).
|
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the ther ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Anchor Pretensioner (APT) Components
...
Removal
•
Use fender covers to avoid damaging painted surfaces.
•
...
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Copyright © www.kirmanual.com 2014-2024