1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the crankshaft position sensor connector (A) and remove
the sensor (B) after removing the installation bolt.
|
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Windshield defrosting and defogging
WARNING - Windshield heating
Do not use the or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and the windshield could ...
Installation
Installation is in the reverse order of removal.
Perform the following :
•
Adjust a shift cable.
•
Refill engine with engine oil.
...