Kia Rio: Removal
|
| [Bank 1 / Intake] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor.
|
| [Bank 1 / Exhaust] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (A).
|
| 3. |
Remove the hanger and the protector.
|
| 4. |
Remove the installation bolt (B), and then remove the sensor.
|
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Rear Torsion Beam Axle Replacement
[Disc Type]
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Components
1. Shoe hold down pin
2. Shoe adjuster
3. Upper return spring
4. Adjusting lever
5. Shoe
6. Adjusting spring
7. Lower return spring
8. Shoe hold spring
...
Specifications
Item
Specification
Type
Electric Power Steering System
Steering gear
Type
Rack & Pinion
Rack stroke
144mm (5.6693 i ...
Copyright © www.kirmanual.com 2014-2024