Kia Rio: Installation
•
|
Install the component with the specified torques.
|
•
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
•
|
DON’T use a cleaner, spray, or grease to sensing element
and connector of the sensor because oil component in them may
malfunction the sensor performance.
|
•
|
Sensor and its wiring may be damaged in case of contacting
with the exhaust system (Exhaust Manifold, Catalytic Converter,
and so on).
|
|
1. |
Installation is reverse of removal.
Heated oxygen sensor installation:
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the connector (A), and then remove the sensor ...
See also:
AGM Battery: Specification
Item
Specification
Model type
AGM 70L-DIN
Capacity [20HR/5HR] (AH)
70/56
Cold Cranking Amperage (A)
760 (SAE) / 610 (EN)
...
Circuit Diagram
...
Starter: Disassembly
1.
Disconnect the M-terminal (A) on the magnet switchassembly.
2.
After loosening the 2 screws (A), detach the magnetswitch assembly
...