To open the sunroof, push the sunroof control lever upward until the sunroof moves to the desired position.
To close the sunroof, push the sunroof lever forward or pull downward until the sunroof moves to the desired position.
WARNING - Sunroof operation
When closing the sunroof, make sure there are no body parts in the movement range of the sliding roof. Parts of the body could become trapped or crushed.
Do not extend the face, neck, arms or body outside the sunroof while driving.
With the sunroof open for an extended period of time, dirt may accumulate on the guide rails causing noise during opening and closing. Periodically remove dirt using a clean cloth.
CAUTION - Sunroof motor damage
If you try to open the sunroof when the temperature is below freezing or when the sunroof is covered with snow or ice, the glass or the motor could be damaged.
Sunshade
When opening the sunroof, the sunshade will also open. Once the sunroof is closed, the sunshade can be manually closed.
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is blown, you must reset your sunroof system as follows:
1.Turn the ignition switch to the ON position and close the sunroof completely.
2.Release the control lever.
3.Push and hold the control lever forward (for more than 10 seconds) until the sunroof tilts and slightly moves. Then, release the lever.
4.Within 3 seconds, push and hold the control lever forward (for more than 5 seconds) until the sunroof is operated as follows;
TILT DOWN → SLIDE OPEN → SLIDE CLOSE
Then, release the control lever. When this is complete, the sunroof system is reset.
✽ NOTICE
If the sunroof is not reset when the vehicle battery is disconnected, discharged, or related fuse is blown, the sunroof may not operate properly.
Back-up Lamp Switch Description
Back up lamp switch is pushed by the reverse lug sliding when select arm,
and switches the back up lamp. ...
Component Location (1)
1. Head lamp (Low/ High)
2. Head lamp (Low)
3. Head lamp (High)
4. Turn signal lamp
5. DRL/ Position lamp
6. Side marker lamp
7. Turn signal lamp (Door mirror)
8. F ...
Adjustment
ETC module learning procedure
When installing new ETC module or re-installing it, ETC module learning
procedure must be performed.
1.
Hold the ignition key o ...