Kia Rio: Installation
•
|
Do not reuse the used injector fixing clip.
|
|
•
|
Install the component with the specified torques.
|
•
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
•
|
Apply engine oil to the injector O-ring.
|
•
|
Do not reuse the used injector O-ring.
|
|
•
|
Do not reuse the used bolt.
|
|
•
|
When inserting the injector, be careful not to damage
the injector tip.
|
|
•
|
Do not reuse the support disc.
|
•
|
Do not reuse the injector rubber washer.
|
•
|
When replacing the rubber washer, the steal plate (A)
part should be faced the cylinder installation part and the
rubber plate (B) part should be faced the injector body part.
|
|
•
|
Do not reuse the combustion seal.
|
|
1. |
Installation is reverse of removal.
|
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
See also:
Auto Light Sensor Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
Special Service Tools
Tool (Number and Name)
Illustration
Use
09546-26000
Strut spring compressor
Compression of coli spring
09624-38000
Crossmemb ...
Specifications
Items
Specifications
Clutch operation method
Hydraulic type
Clutch cover
Type
Diaphragm spring strap
Clutch disc Ty ...