Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the purge control solenoid valve connector (A).
|
| 3. |
Disconnect the vapor hoses (B) from the purge control solenoid
valve.
|
| 4. |
Remove the valve after removing the bolt (C).
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV termi ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Audio Remote Control Installation
1.
Reassemble the steering wheel remote control switch after connecting
the connector.
2.
Reassemble the steering wheel.
...
Rear Shock Absorber Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
Copyright © www.kirmanual.com 2014-2024