Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the CVVT oil control valve connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the valve from
the engine.
[Bank 1 / Intake]
[Bank 1 / Exhaust]
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV termina ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description
Underdrive brake control solenoid valve(UD/B_VFS) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the underdrive brake.
...
Ignition Switch Assembly Installation
1.
Install the key lock cylinder.
When assembling, the key must be insert ...
Anchor Pretensioner (APT) Description
Front seat belt anchor pretensioner operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat a ...
Copyright © www.kirmanual.com 2014-2024