Kia Rio: DC/DC Converter: Component Location - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2024 Service ManualKia Rio: DC/DC Converter: Component Location


1. DC/DC Converter

AGM Battery: Cleaning
1. Make sure the ignition switch and all accessories are in the OFF position. 2. Disconnect the battery cables (negative first). ...

DC/DC Converter: Circuit Diagram
   In the ISG mode, if the power of an audio system turnsOFF by drawdown while “Auto Starting” or “Idle Starting”functi ...

See also:

Auto Defogging Sensor (FATC only) Replacement
1. Remove the auto defogging sensor cover (A). 2. Disconnect the connector (B) and then remove the auto defogging sensor (C). ...

Yaw-rate and G Sensor Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the front seat (LH) assembly. (Refer to the Bo ...

Troubleshooting
Problem Symptoms Table Use the table below to help you find the cause of theproblem. The numbers indicate the priority of the likecause of the problem. Check each part in order. ...

Copyright © www.kirmanual.com 2014-2024