1. |
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in and when it is released.
|
2. |
The stop lamp switch is in good condition if there is no continuity
when plunger (A) is pushed.
|
Power Window Switch Inspection
Power Window Main Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to ...
Auto Light Sensor Inspection
In the state of IGN1 ON, when multi function switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor ...
Windshield Wiper-Washer Switch Installation
1.
Install the wiper switch.
2.
Install the steering column upper and lower shrouds.
...