Whenever the high pressure fuel pump, fuel pipe, delivery pipe,
or injector is removed immediately after shutting off the engine, an
injury may be caused by the release of highly pressurized fuel. Release
the residual pressure in the high pressure fuel line by referring to
the "Residual fuel pressure release procedure" below before removing
any high pressure fuel system components.
|
Wear safety glasses and fuel resistant gloves.
|
1. |
Turn the ignition off and disconnect the battery negative cable.
|
2. |
Remove the rear seat cushion. (Refer to Bady - "Seat")
|
3. |
Remove the service cover (A).
|
4. |
Disconnect the fuel pump connector (A).
|
5. |
Disconnect the electrical connector from the high pressure fuel
pump.
|
6. |
Reconnect the battery negative cable.
|
7. |
Run the engine for about 20 seconds to lower the pressure in both
the high or low pressurelines. The engine may shut off within the 20
second period. If not, turn the engine off.
|
8. |
Proceed with the service or repair. Use rags to cover opening
and catch spills when opening up the high pressure system.
|
9. |
Reinstall / re-connect all components in reverse order of removal.
Start engine and confirm proper operation, and make sure there are no
fuel leaks.
|
10. |
After completing, clear DTC(s) using GDS scan tool (the procedure
described above will cause DTC to set).
|
Engine compartment
1. Engine Coolant Reservoir
2. Engine Oil Filler Cap
3. Brake/Clutch Fluid Reservoir
4. Air Cleaner
5. Fuse Box
6. Negative Battery Terminal
7. Positive Battery Terminal
8. Radiator Cap
9. E ...
Seat belt restraint system
Seat belts are designed to bear upon the bony structure of the body, and should
be worn low across the front of the pelvis or the pelvis, chest and shoulders, as
applicable; wearing the lap sectio ...
Description
System Overview
The System offers the following features:
-
Human / machine interface through a 1-stage button, for terminal
switching and engine start.
...