1. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
2. |
Remove the rear seat [LH] (Refer to “Seat” in BD group).
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel pump connector (A).
|
5. |
Disconnect the fuel feed tube quick connector (B).
|
6. |
Disconnect the fuel tank pressure sensor connector (C).
|
7. |
Disconnect the vapor tube quick-connector (D).
|
8. |
Remove the plate cover (E) after removing the installation bolts,
and then remove the fuel pump from the fuel tank.
|
Hazard Lamp Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or trim remover, remove the hazard lamp switch
(A).
...
Ambient Temperature Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the engine room RH side under cover.
(Refer to EM group - “Engine and Transax ...
Specifications
Items
Specifications
Rated voltage
DC 12V
Operating temperature range
-30°C ~ +80°C (-22 ~ +176°F)
Rated load
Dimmer and ...