Kia Rio: Filler-Neck Assembly Removal
| 1. |
Open the fuel filler door, and then remove the filler-neck assembly
mounting screws (A).
|
| 2. |
Disconnect the fuel filler hose (A) and the vapor hose (B).
|
| 3. |
Remove the filler-neck assembly from the vehicle after removing
the bracket mounting bolt (A).
|
Fuel Filter Replacement
1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel
sender conn ...
Filler-Neck Assembly Installation
1.
Installation is reverse of removal.
Filler-neck assembly bracket
installation nut :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...
See also:
In car sensor (FATC only) Description
The In-car air temperature sensor is built in the heater & A/C control
unit.
The sensor contains a thermistor which measures the temperature of the
inside. The signal decided by the r ...
Hazard warning flasher lighting
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as po ...
Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...
Copyright © www.kirmanual.com 2014-2024