In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be injury caused by
leakage of the high pressure fuel. Before repairing the high pressure
system, be sure to release the residual pressure in fuel line as step
2 in below procedure.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
3. |
Remove the intake manifold (Refer to "Intake And Exhaust System"
in EM group).
|
4. |
Disconnect the injector connectors (A) and the rail pressure sensor
connector (B).
|
5. |
Remove the high pressure fuel pipe (C).
|
6. |
Remove the engine oil gauge.
|
7. |
Remove the installation bolt (D), and then remove the delivery
pipe and injector assembly from the engine.
|
Oil Pressure Switch: Inspection
1.
Check the continuity between the terminal and the body with an
ohmmeter. If there is no continuity, replace the oil pressure switch.
2.
...
Front Lower Arm Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the lower arm for deformation.
3.
Check the all bolts ...
Component Location
1. Tailgate actuator & switch
2. Rear door switch
3. Body control module
4. Key warning switch
5. Front door switch
6. Front door lock actuator & switch
7. Rear do ...