1. |
Measure the clutch pedal height (from the face of the pedal pad
to the floorboard) and the clutch pedal clevis pin play (measured at
the face of the pedal pad.)
|
1. |
Disconnect 2P-connector from a ignition lock switch.
|
2. |
Disconnect the ignition lock switch. (if you can install a tester
with the switch fixed, this step can be omissible)
|
3. |
Check for continuity between terminals. (refer to the table below)
|
4. |
If there is difference between what tested and the table above,
replace the ignition lock switch with a new one.
|
Compressor Components
1. Center Bolt
2. Hub Bolt
3. Hub Assembly
4. Snap Ring
5. Pulley
6. Compressor Assembly
7. Electric Control Valve (ECV)
...
AVN Head Unit Installation
AVN Head Unit
1.
Connect the AVN head unit connectors and cable.
2.
Install the AVN head unit.
3.
Install t ...
Dynamic Damper Replacement
1.
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
2.
Remove the TJ joint assembly. (Refer to DS group - “TJ joint”)
...