Clutch Release Cylinder Air Bleeding Procedure |
Use the specified fluid. Avoid mixing different brands of fluid.
|
Specified fluid: SAE J1703
(DOT 3 or DOT 4)
|
1. |
After disconnecting a cap from the clutch release cylinder air
bleeder, insert a vinyl hose in the plug.
|
2. |
Loosening the plug screw, press and release the clutch pedal about
10 times.
|
3. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards,
raise the pedal with a hand.
|
4. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and retighten it with the pedal pressed. Raise it again, then.
|
5. |
Repeat the step 4 two or three times. (until there is no bubble
in the fluid)
|
6. |
Refill the clutch master cylinder with the specified fluid.
|
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the ther ...
Dimensions Projected
1.
These are the dimensions measured when the measurement points
are projected from the vehicle's surface, and are the reference dimensions
used for used for body ...
Components
1. Hands free call switch
2. Mic
3. Front left speaker
4. Front right speaker
5. Audio head unit (hands free control)
※ There is no hands free jack. Thi ...