1. |
Remove the following items;
|
2. |
Remove the following items;
|
3. |
Remove the ground cable bolt (A) and tube bracket bolt (B).
|
4. |
Remove the transaxle upper mounting bolt (B-2ea) and the start
motor mounting bolt (A-2ea).
|
5. |
Remove the cowl top cover.
(Refer to BD group.)
|
6. |
Using the engine support fixture (Support SST No.: 09200-2S200,
Adapter SST No.: 09200-1P000, 4X000, Beam SST No.: 09200-38001/3N000),
hold the engine and transaxle assembly safely.
|
7. |
Remove the mounting cover (A).
|
8. |
Remove the transaxle support mounting bracket bolts (A-2ea).
|
9. |
Remove the transaxle support mounting bracket bolts (A-3ea).
|
10. |
Lifting up the vehicle.
|
11. |
Remove the under cover (A).
|
12. |
Remove the clutch release cylinder assembly (A) by removing bolts
(B-2ea).
|
13. |
Remove the drive shaft assembly.
(Refer to "Drive shaft assembly" in DS group.)
|
14. |
Remove the drive shaft cover (A).
|
15. |
Remove the brackets (A).
|
16. |
Remove the roll rod bracket (C) after removing bolt (A,B).
|
17. |
Remove the mounting bolts (A-3ea, B-2ea) of lower part of the
transaxle, and the left side cover and remove the transaxle assembly
by supporting it with a jack.
|
Starter: Cleaning
1.
Do not immerse parts in cleaning solvent. Immersing the yoke assembly
and/or armature will damage the insulation. Wipe these parts with a
cloth only.
...
Air bag warning light
The purpose of the air bag warning light in your instrument panel is to alert
you of a potential problem with your air bag-Supplemental Restraint System (SRS).
When the ignition switch is turned O ...
Intake Manifold: Components
1. Intake manifold
2. Intake manifold gasket
3. Electronic throttle body gasket
4. Electronic throttle body
5. Bracket
...