Kia Rio: Valve Body Installation
1. |
Installation is the reverse of removal.
|
After replacement or reinstallation procedure of the valve body
assembly, must perform procedures below.
|
•
|
The gasket of the valve body gasket (A) use new one.
|
•
|
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
|
•
|
Perform TCM learning after replacing the valve body to
prevent slow transaxle response, jerky acceleration and jerky
startup. (Refer to "Automatic transaxle control system (Repair
procedures)" in this group)
|
|
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...
The 6-spd automatic transaxle consists of an overdrive clutch (OD/C),
a one-way clutch (OWC), a lower and reverse brake (LR/B), an underdrive brake
(UD/B), a 26 brake (26/B), and a 35R clutch ...
See also:
Engine Number
1.
Engine fuel
- G : Gasoline
2.
Engine range
- 4 : 4 cycle 4 cylinder
3.
Engine developme ...
Operation and Leakage Check
Check all of the following items:
Component
Procedure
Brake Booster (A)
Check brake operation by applying the brakes during a test drive.
If the brak ...
Room Lamp Removal
Room Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove room lamp lens (B).
3.
Remove ...