1. |
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harness connector as TCM side check
point. If the problem is found, repair it.
|
2. |
TEST TCM CONNECTOR: Disconnect the TCM connector and visually
check the ground terminals on TCM side and harness side for bent pins
or poor contact pressure. If the problem is found, repair it.
|
3. |
If problem is not found in Step 1 and 2, the TCM could be faulty.
If so, make sure there were no DTC's before swapping the TCM with a
new one, and then check the vehicle again. If DTC's were found, examine
this first before swapping TCM.
|
4. |
RE-TEST THE ORIGINAL TCM: Install the original TCM (may be broken)
into a known-good vehicle and check the vehicle. If the problem occurs
again, replace the original TCM with a new one. If problem does not
occur, this is intermittent problem (Refer to “Intermittent Problem
Inspection Procedure” in Basic Inspection Procedure).
|
Oil Pump Components
1. Oil pump cover
2. Oil pump housing
3. Driven gear
4. Drive gear
5. Oil seal
6. Bushing-housing
7. Reaction shaft
8. Bushing-reaction shaft
9. Sleeve
10 ...
Output Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(0.85 ~ 1.3)
0.0335 ~ 0.0512
Output volt ...
Audio Unit Removal
•
Take care not to scratch the center fascia panel and related
parts.
...