1. |
Turn ignition switch OFF.
|
2. |
Disconnect the solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
|
Description
The hydraulic system consists of oil, an oil filter, an oil pump, and
a valve body (valves and solenoid valves). The oil pump is powered by the engine.
ATF passes through the oil filter and g ...
Description
Automatic transaxle system relies on various measurement data to determine
the current control status and extrapolate the necessary compensation values.
These values are used to control the a ...
Front Impact Sensor (FIS) Installation
•
Do not turn the ignition switch ON and do not contact
the battery cable while replacin ...