1. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after draining the automatic transaxle
fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)"
in this group)
|
4. |
Remove the valve body cover (A) and eyebolt (B).
|
5. |
Remove the bolt (3ea) after disconnecting the solenoid valve connector
(B) and the oil temperature sensor connector (A).
|
6. |
Remove the solenoid valve (B) after removing the solenoid support
(A).
|
Installation
1.
Install the intake CVVT (A) and exhaust CVVT (B).
Tightening torque :
63.7 ~ 73.5 N.m (6.5 ~ 7.5 kgf.m, 47.0 ~ 54.2 lb-ft)
...
Removal
1.
Turn ignition switch OFF, and disconnect the negative (-) battery
cable.
2.
Remove the battery and ECM.
(Refer to the Engine Ele ...
In car sensor (FATC only) Description
The In-car air temperature sensor is built in the heater & A/C control
unit.
The sensor contains a thermistor which measures the temperature of the
inside. The signal decided by the r ...