1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub .
|
3. |
Remove the brake caliper mounting bolts , and then hold the brake
caliper assembly (B) with wire.
|
4. |
Remove the brake hose mounting bracket (A) & wheel speed sensor
(B) & bracket (C).
|
5. |
Remove driveshaft nut (A) from the front hub under applying the
brake.
|
6. |
Remove the tie rod end ball joint from the knuckle.
|
7. |
Remove the lower arm (A) from the knuckle.
|
8. |
Disconnect the driveshaft (A) from the front hub assembly.
|
9. |
Loosen the strut mounting bolts and then remove the knuckle assembly
(A).
|
10. |
Install in the reverse order of removal.
|
Exhaust Manifold: Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
Tightening torque :
Witho ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust ...
Removal
1.
Disconnect the battery terminal (A).
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - & ...