|
1. |
Remove the Front Driveshaft. (Refer to DS group - “Front Driveshaft”)
|
2. |
Remove the circlip (B) from the driveshaft spline (A).
|
3. |
Remove both boot bands from the TJ case.
|
4. |
Remove the TJ case (A).
|
5. |
Remove the snap ring (A) from the shaft.
|
6. |
Remove the spider assembly (B) from the driveshaft (A) using the
special tool (09495-33000).
|
7. |
Clean the spider assembly.
|
8. |
Remove the TJ boot (A).
|
Ignition Switch Assembly Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to the ST group - & ...
Input Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Door Switch Inspection
1.
Remove the door switch and check for continuity between the terminals.
...