1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
|
2. |
Using the alignment marks (D) made during disassembly as a guide,
install the spider assembly (A) and snap ring (B) on the driveshaft
splines (C).
|
3. |
Add specified grease to the joint boot as much as it was wiped
away at inspection.
|
4. |
Install the both boot band.
|
5. |
To control the air in the TJ boot, keep the specified distance
between the boot bands when they are tightened.
|
6. |
Using the SST(09495-3K000), secure the TJ boot bands.
|
7. |
Install the Front Driveshaft. (Refer to DS group - “Front Driveshaft”)
|
Installation
1.
Install in the reverse order of removal.
•
...
Air bag collision sensors
(1) SRS control module
(2) Front impact sensor
(3) Side impact sensor
WARNING - Air bag sensors
Do not hit or allow any objects to impact the locations where air bag
or sensors are installed ...
Special Service Tools
Tool (Number and name)
Illustration
Use
Crankshaft front oil seal installer
(09455-21200)
Installation of the front oil seal
Va ...