1. |
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
|
2. |
Remove the TJ joint assembly. (Refer to DS group - “TJ joint”)
|
3. |
Remove the remove the both side of band (B) of the dynamic damper
(A).
|
4. |
Fix the driveshaft (A) with a vice (B) as illustrated.
|
5. |
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper when the dynamic damper is removed.
|
6. |
Seperate the dynamic damper (A) from the shaft (B) carefully.
|
Adjustment
Battery charging
In general, vehicle battery charging system has three forms.
1.
Constant current charge: The battery voltage gradually rises by
chargi ...
Back-up Lamp Switch Inspection
1.
Disconnect the back up lamp switch connector (A).
2.
Check the continuity between no. 1 and 2 terminals of backup lamp
switch. W ...
In car sensor (FATC only) Description
The In-car air temperature sensor is built in the heater & A/C control
unit.
The sensor contains a thermistor which measures the temperature of the
inside. The signal decided by the r ...