1. |
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
|
2. |
Install the dynamic damper.
|
3. |
Install the dynamic damper band.
|
4. |
Using the SST(09495-3K000), secure the TJ boot bands (A).
|
5. |
Install the TJ joint assembly. (Refer to DS group - “TJ joint”)
|
6. |
Install the front driveshaft. (Refer to DS group - “Front Driveshaft”)
|
4Door Rear Body
Side outer panel rear corner
Side outer panel rear corner
Side outer panel rear corner
...
SS-B Solenoid Valve(ON/OFF) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Installation
1.
Connect the horn connector, then reassemble the horn.
...