1. |
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
|
2. |
Remove the TJ joint assembly. (Refer to DS group - “TJ Joint”)
|
3. |
Remove the Dynamic damper. (Refer to DS group - “Dynamic Damper”)
|
4. |
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot
bands (A).
|
5. |
Remove the BJ boot.
|
6. |
Install in the reverse order of removal.
|
Compressor Oil Specification
1.
The HFC-134a system requires synthetic compressor oil (PAG) whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
...
Smart key
With a smart key, you can lock or unlock a door and even start the engine without
inserting the key.
The functions of the buttons on a smart key are similar to the remote keyless
entry. (Refer ...
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mul ...