Kia Rio: Rear Hub - Carrier Components
| [Drum Type] |
| 1. Rear torsion beam assembly 2. Brake assembly 3. Rear wheel hub assembly |
4. Rear brake disc 5. Rear brake disc mounting screw |
| [Disc Type] |
| 1. Rear torsion beam assembly 2. Dust cover |
3. Rear wheel hub assembly 4. Rear brake disc |
Rear Hub - Carrier Replacement
[Drum Type]
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
See also:
Inspection
Front Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Anchor Pretensioner (APT) Description
Front seat belt anchor pretensioner operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat a ...
Copyright © www.kirmanual.com 2014-2024