1. |
Remove the front wheel & tire.
|
2. |
Disconnect the stabilizer link with the front strut assembly after
loosening the nut.
|
3. |
Loosen the nut and then remove the tie-rod end (A) with the front
axle by using SST(09568-34000).
|
4. |
Loosen the nut and then remove the lower arm (A).
|
5. |
Loosen the bolt (A) and then disconnect the universal joint assembly
from the pinion of the steering gear box.
|
6. |
Remove the rubber hanger (A).
|
7. |
Loosening the roll rod (A) mounting bolts and nuts.
|
8. |
Loosen the bolts & nuts and then remove the front sub frame (A).
|
9. |
Remove the stabilizer (A) from the front sub frame by loosening
the mounting bolts & nuts.
|
10. |
Disconnect the stabilizer link (A) with the stabilizer bar by
loosening the nut.
|
11. |
Remove the bushing (A) and the clamp (B) from the stabilizer bar.
|
12. |
Installation is the reverse of removal.
|
Antenna Installation
1.
Install the roof antenna, then connect the cable and the connector.
2.
Install the rear roof trim.
...
Component Location (2)
[4 Door]
1. Back up lamp
2. Turn signal lamp
3. Tail lamp/ Stop lamp
4. Tail lamp
5. Stop lamp
6. Side marker lamp
7. High mounted stop lamp
8. Lic ...
Description
Idle Stop & Go (ISG) function automatically switches off the engine when
the car is at a standstill if the and starts it again as soon as the brake pedal
is released. This not only reduce ...