Kia Rio: TPMS Receiver Operation
1. |
General Function
A. |
Auto-learn takes place only once per Ignition cycle.
|
B. |
On successful completion, 4 road wheel sensor ID's are
latched into memory for monitoring.
|
C. |
Until Auto-learn completes, previously learned sensors
are monitored for under inflation / leak warnings.
|
|
2. |
General Conditions to Learn New Sensors:
A. |
Receiver must determine that it is confident that sensor
is not temporary:
|
2) |
Uses confidence reduction of previously learned
sensors.
|
|
B. |
Typical time at driving continuously over 12.4 mph(20
kph) to learn a new sensor is up to 20 minutes.
|
|
3. |
General Conditions to Un-Learn a sensor that is removed:
A. |
It takes less than 20 minutes at 12.4 ~ 18.6 mph(20 ~
30kph).
|
B. |
Confidence reduction is dependent on time which vehicle
is driven at speed greater than or equal to 12.4 mph(20 kph).
|
|
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this
state. ...
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
...
See also:
Defroster
CAUTION - Conductors
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window. ...
Relay Box (Passenger Compartment) Removal
Passenger Compartment Junction Box
1.
Disconnect the negative(-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to th ...
General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before starting
work.
The s ...