Kia Rio: Steering Column and Shaft Inspection
| 1. |
Check the steering column for damage and deformation.
|
| 2. |
Check the steering column for damage and deformation.
|
| 3. |
Check the join bearing for damage and wear.
|
| 4. |
Check the tilt bracket for damage and cracks.
|
| 5. |
Check the key lock assembly for proper operation and replace it
if necessary.
|
Steering Column and Shaft Disassembly
Key lock assembly
1.
Make a groove on the head of special bolts (A) with a chisel.
2.
Loosen the special bolt using a screw driver a ...
Steering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
See also:
Output Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(0.85 ~ 1.3)
0.0335 ~ 0.0512
Output volt ...
Starter: Reassembly
1.
Reassemble in the reverse order of disassembly.
...
Ending voice recognition
While Voice Recognition is operating
Press and hold
the key on
the steering remote controller (over 0.8 seconds)
While using voice command, pressing any steering wheel control or a differen ...
Copyright © www.kirmanual.com 2014-2024