Kia Rio: Steering Gear box Components
| 1. Tie-rod end 2. Lock nut 3. Bellows clip 4. Bellows 5. Tie rod |
6. Rack bar 7. Dust packing 8. Dust cap 9. Oil seal 10. Pinion plug |
11. Pinion assembly 12. Yoke plug 13. Yoke spring 14. Support yoke assembly 15. Rack housing |
Steering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
Steering Gear box Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
See also:
Removal
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
...
Receiver-Drier Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with L wrench
(A).
Tightening torq ...
Overhead Console Lamp Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the overhead console
lamp assembly.
...
Copyright © www.kirmanual.com 2014-2024