Kia Rio: SRS Control Module (SRSCM) Removal
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Remove the floor console.
(Refer to the Body group - "Console")
|
| 4. |
Remove the rear heating joint duct (A).
|
| 5. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A).
|
| 6. |
Remove the SRSCM mounting nuts (3EA) from the SRSCM, then remove
the SRSCM.
|
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
See also:
Components
1. Brake pedal member assembly
2. Stop lamp switch
3. Pedal bushing
4. Return spring
5. Brake pedal
6. Brake pedal pad
...
Audio system
If you install an aftermarket HID head lamp, your vehicle’s audio and electronic
device may malfunction.
Antenna
Your vehicle uses a roof antenna to receive both AM and FM broadcast signals.
T ...
Specification
Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0.75 ± 15％ [20°C (68°F)]
Secondary Coil R ...
Copyright © www.kirmanual.com 2014-2024